9. E-Textiles and Wearables II#

This week i continued working with servos and arduino from week 5, this time i was able to control each servo with a seperate ultrasonic

I also tried making an speaker using copper wire and masking tape

Speaker#

Servos & Arduino#

Code Example#

Use the three backticks to separate code.

// the setup function runs once when you press reset or power the board
void setup() {
  // initialize digital pin LED_BUILTIN as an output.
  pinMode(LED_BUILTIN, OUTPUT);
}

// the loop function runs over and over again forever
void loop() {
  digitalWrite(LED_BUILTIN, HIGH);   // turn the LED on (HIGH is the voltage level)
  delay(1000);                       // wait for a second
  digitalWrite(LED_BUILTIN, LOW);    // turn the LED off by making the voltage LOW
  delay(1000);                       // wait for a second
}

Video#

From Vimeo#

Sound Waves from George Gally (Radarboy) on Vimeo.

From Youtube#

3D Models#

Dita's Gown by Francis Bitonti Studio on Sketchfab